Zebra Technologies 2844 user manual AutoSense Gap Sensor Adjustment

Page 16

Installation and Operation

AutoSense Gap Sensor Adjustment - continued

When Indicator

Flashes, Release

Feed Button

Printer Advances

Media and Prints

Status Summary

Note: Printer is in diagnostic dump mode

Tap Feed Button

To Begin Normal

Operation

Note: Printer prints “out of DUMP”

UKQ1935 16 V3.21

Serial port : 96,N,8,1

Image buffer size:1032K Fmem:000.0K,016.4K avl Gmem:000K,0593K avl Emem:000K,0593K avl I8,0,001 rY

S2 D10 R016,000 ZT UN

q800 Q01225,026 Option:

04 08 13 now in DUMP

										n
								o
							w
					in						0
				D						4
			U					0					O
	M						8						O
	P					1					p
					3				tio						q
								n							q
							:							8
												0
											0					S
									Q							S
								1							2
							0						D
						2							D
					9							1				8I
				,0							0					8I
			2						R						,0
			2					0						,0
		5					1							,0				E
						6						0						E
					,0						1						m
				0				Yr								e
			0					Yr							m			G
	Z												0:					G
T												0						m
U											0						e			F
N										K						m				F
								,0							0:				m
							2							0				e
						4						0						e
					1						K						m			Im
				K					0,							0:				Im
	lva						42							,00				ega

If the indicator remains orange or red, see the troubleshooting steps.

10	980348-001 Rev. A

Image 16

Contents Thermal Printer User’s Manual 2844 980348-001 Rev. a Foreword LP 2844 and TLP 2844 Thermal PrintersShock Hazard Warning Table of Contents 980348-001 Rev. a Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Serial ParallelStep ➌ Load Media Power onOpen Cover Open Guides Install Roll Load MediaRelease Cover Close CoverPower OFF Step ➍ AutoSense Media Gap SensingAutoSense Gap Sensor Adjustment Step ➎ Install Software Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Thread Ribbon Through CarriageStep ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonPartially Used Push Supply Roll OutUsing the Label Dispenser Open DoorUsing Fan-Fold Media Insert MediaUsing the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBCleaning RubPen Across Dark AreaCleaning the Platen Preparing Media Before LoadingLabel Rolls Tag Stock Rolls980348- 001 a