Zebra Technologies 2844 user manual Load Media, Install Roll

Page 13

Installation and Operation

Load Media - continued

Remove the outside length of media

MOVIE

For more infor- mation on media preparation, refer to Appendix A.

Install Roll

Note: Find the instructions for preparing media in Appendix A.

Close Guides to the Width of the Media

Note: When using linerfree labels, adjust the guides to the widest position

980348-001 Rev. A

7

Image 13

Contents Thermal Printer User’s Manual 2844 980348-001 Rev. a LP 2844 and TLP 2844 Thermal Printers ForewordShock Hazard Warning Table of Contents 980348-001 Rev. a Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Serial Parallel Step ➋ Attach Interface CableStep ➌ Load Media Power onOpen Cover Open Guides Load Media Install RollClose Cover Release CoverStep ➍ AutoSense Media Gap Sensing Power OFFAutoSense Gap Sensor Adjustment Step ➎ Install Software Direct or Transfer? Using Options Step ➊ Prepare Ribbon Thread Ribbon Through Carriage Step ➋ Install Supply RollStep ➌ Install Take-Up Core Attach Ribbon to Take-Up Core Remove Slack From Ribbon Step ➍ Tighten RibbonPush Supply Roll Out Partially UsedOpen Door Using the Label DispenserInsert Media Using Fan-Fold MediaUsing the Media Cutter 980348-001 Rev. a Problem Solution or Reason Appendix a TroubleshootingRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable Bus USB For the cable connectorsRub CleaningPen Across Dark AreaCleaning the Platen Before Loading Preparing MediaLabel Rolls Tag Stock Rolls980348- 001 a