Zebra Technologies 2844 user manual 980348-001 Rev. a

Page 28

Clearing the If the blade cuts through labels, adhesive can Media Cutter jam the cutter.

Turn OFF (O) printer power and unplug the power and interface cables before clearing the cutter.

Keep the cutter dry. Never use any solutions or solvents to clean the blade.

After removing debris, plug in the power and interface cables, turn on the printer, then test for normal operation.

22

980348-001 Rev. A

Image 28
Contents Thermal Printer User’s Manual 2844 980348-001 Rev. a Foreword LP 2844 and TLP 2844 Thermal PrintersShock Hazard Warning Table of Contents 980348-001 Rev. a Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Serial ParallelStep ➌ Load Media Power onOpen Cover Open Guides Install Roll Load MediaRelease Cover Close CoverPower OFF Step ➍ AutoSense Media Gap SensingAutoSense Gap Sensor Adjustment Step ➎ Install Software Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Thread Ribbon Through CarriageStep ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonPartially Used Push Supply Roll OutUsing the Label Dispenser Open DoorUsing Fan-Fold Media Insert MediaUsing the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBCleaning RubPen Across Dark AreaCleaning the Platen Preparing Media Before LoadingLabel Rolls Tag Stock Rolls980348- 001 a