Nortel Networks Instant Internet 400 Unit manual UL listing/C-UL listing

Page 8

8

2.Your telephone company may make changes to its facilities, equipment, operation, or procedures that could affect the proper functioning of your equipment. The telephone company will notify you in advance of such changes to give you an opportunity to maintain uninterrupted telephone service.

3.If the unit causes harm to the telephone network, the telephone company may temporarily discontinue your service. If possible, they will notify you in advance, but, if advance notice is not practical, you will be notified as soon as possible and will be informed of your right to file a complaint with the FCC.

4.You are required to notify the telephone company when you disconnect the unit from the network.

UL listing/C-UL listing

This information technology equipment is UL-Listed and C-UL-Listed for the uses described in this and accompanying documents.

Connecting an Instant Internet unit to the network

Important safety information

To avoid contact with electrical current:

Never install electrical wiring during an electrical storm

Never install telephone jacks in wet locations unless that jack is specifically designed for wet locations

Use caution when installing or modifying telephone lines

Use a screwdriver and other tools with insulated handles

You and those around you should wear safety glasses or goggles

Do not place telephone wiring or connections in any conduit, outlet or junction box containing electrical wiring

Warning: Do not work on your telephone wiring if you wear a pacemaker. Telephone lines carry electrical current.

Installation of inside wire may bring you close to electrical wire, conduit, terminals and other electrical facilities. Extreme caution must be used to avoid electrical shock from such facilities. You must avoid contact with all such facilities.

Telephone wiring must be at least 6 feet from bare power wiring or lightning rods and associated wires, and at least 6 inches from other wire (antenna wires, doorbell wires, wires from transformers to neon signs), steam or hot water pipes, and heating ducts.

Before working with existing inside wiring, check all electrical outlets for a square telephone dial light transformer and unplug it from the electrical outlet. Failure to unplug all telephone transformers can cause electrical shock.

Do not place a jack where it would allow a person to use the telephone while in a bathtub, shower, swimming pool, or similar hazardous location.

Protectors and grounding wire placed by the service provider must not be connected to, removed, or modified by the customer.

Specific information related to different types of communication connections

Connecting an Instant Internet unit containing an analog modem

It is not necessary to notify the telephone company before installing the modem. However, the telephone company may request the telephone number(s) to which the unit is connected and the related FCC information including the FCC Part 68 registration number and the ringer equivalence number.

Be sure that the telephone line you are connecting the modem to is a standard analog line and not a digital (PBX), party, or coin telephone line. If the modem is malfunctioning, it may affect the telephone lines. In this case, disconnect the modem until the source of the difficulty is traced.

300867-G

Image 8
Contents Setting Up the BayStack Instant Internet 400 Unit Copyright 2000 Nortel Networks TrademarksStatement of conditions USA requirements onlySetting Up the BayStack Instant Internet 400 Unit Japan/Nippon requirements onlyTaiwan requirements Canada requirements onlyNortel Networks NA Inc. software license agreement Canada CS-03 -- Règles et règlementsSetting Up the BayStack Instant Internet 400 Unit Modular components used in this assembly FCC Part 68 compliance statement Connecting an Instant Internet unit to the network UL listing/C-UL listingNT1 Instant Internet Isdn Device 300867-G Contents Chapter DIP switch settings ContentsFigures Figures 300867-G Tables Tables 300867-G Preface Before you beginAcronyms PrefaceRelated publications How to get help Chapter Introduction Instant Internet packageAvailable options IntroductionRequirements and compatibility Introduction 300867-G Chapter Installation preparation Preparing for Internet accessMaking decisions Selecting an Internet service providerInstallation preparation Installation checklist Installation checklistInstallation preparation Installation checklist Installation worksheet ISP Connection Alternate Phone NumberT1 Connection Information Chapter Instant Internet 400 hardware installation Getting to know your Instant Internet 400 unitInstant Internet 400 hardware installation Rear panel of the Instant Internet 400 unitLAN interfaces Interface name Interface card TypeCommunication interfaces Instant Internet quick installation DDSInstant Internet 400 hardware installation Mounting your Instant Internet unit in a rack Removing screws from cover of Instant Internet 400 unit 10046FA Instant Internet 400 hardware installation 300867-G Chapter DIP switch settings DIP switchesSingle token ring switch settings Switch settings for normal operationSwitch settings for token ring speed Dual token ring switch settings Dual token ring 16 Mb/s Tok1 / 16 Mb/s Tok2Dual token ring 16 Mb/s Tok1 / 4 Mb/s Tok2 Dual token ring 4 Mb/s Tok1 / 16 Mb/s Tok2Switch settings for special configurations Switch settings for resetting the passwordSwitch settings for restoring factory default conditions Resetting your Instant Internet unit Refer to Switch settings for special configurations onInterpreting LEDs Chapter LEDs support and diagnostic functionsLEDs at power-up sequence Recognizing single token ring speed Recognizing dual token ring speedLEDs during operation LED status and appearance during operationLEDs support and diagnostic functions 300867-G Environmental specifications Appendix a Technical specificationsPhysical specifications Appendix a Technical specifications 300867-G Appendix B Adapter cable pinout diagrams Adapter cable part numbersAppendix B Adapter cable pinout diagrams Adapter cable21 DCE adapter cable diagram DCE adapter cableAppendix B Adapter cable pinout diagrams 300867-G Numbers SymbolsIndex Index Index Index