Filters and QoS Configuration for ERS 5500 |
|
|
Technical Configuration Guide | v2.0 |
|
12.2Configuration Example 1 – Traffic Meter Using Policies
Figure 5: Traffic Meter Example
The following CLI commands show how to configure a QoS Policy using a
•Setup one Policy with three classifiers metered with the following TCP flows: o For UDP dst port 80, meter traffic at 10M
o For UDP dst port 69, meter traffic at 5M o For UDP dst port 137, meter traffic at 1M
•Set the meter bucket size (committed burst) for all meters to maximum value
•Add the policy to ports 5 and 6
NOTE: As all three classifiers use the same mask, we will create a classifier block to group all three classifiers.
At this time, it is only possible to configure traffic meters using policies. It is not possible to add traffic meters via ACL’s.
12.2.1 ERS5500 Configuration Using Policies
12.2.1.1 Configure the Interface Role Combination
For this example, we will configure a new role combination with port members 5 and 6. You have the choice of assigning a policy directly at a port level or using an interface role.
By default, all ports are set for untrusted using the allBayStacklfcs Role Combination. In this example, we will configure a new Role Combination as untrusted and assign it to port 5 and 6.
ERS5500 Step 1 – Create the Interface Role Combination and name is “q2”
12.2.1.2 Configure the IP elements
Configure three IP elements for UDP destination ports 80, 69, and 137.
ERS5500 Step 1 – Create the IP elements
___________________________________________________________________________________________________________________________
Nortel Confidential Information Copyright © 2008 Nortel Networks. All Rights Reserved. |
|
External Distribution | 44 |