Atek electronic OnBoard manual Tab

Page 17

Setup

You can use the OnBoard Travel Keyboard flat or in a tilt position. To tilt the keyboard, you will use the top cover as a stand. After removing the top cover from the keyboard, put the cover upside down on your work surface with what was the front edge of the cover now at the back. Next, place the front edge of the keyboard inside the upside down top cover and then let the back of the keyboard lean against the back edge of the upside down top cover. The back edge of the keyboard should land just inside the two little plastic tabs so that it is stable.

PgUp

PgDn 0

Ins

Del

Shif t

End

P g D n

Enter

 

Enter

 

Hom

 

4

1

5

6

2

 

3

 

 

F11

Backspace

F12

Hom

 

N

Lock

u

m

7

*

8

 

9

 

PgUp

 

E nd

Insert

Del

Tab

The top cover has footpads on it, so no matter whether you use the keyboard flat or in the tilt position, it should not slide on your work surface.

OnBoard User’s Manual, Page 16

Image 17
Contents Page Need HELP? Health & Safety Information Table of Contents Introduction Compatibility & System Requirements Number of Keys FeaturesOverall Size Size and position of non-crucial keysNumeric keypad closer to main part of keyboard Features Features Features Features Specially Protected Characters TiltSpecial Cord Opening the keyboard SetupAlt Post Tab Closing the keyboard Push cord into groove Cover Installation Problem Keyboard does not Work TroubleshootingTroubleshooting Troubleshooting Possible Cause Bad connection Troubleshooting MAINTENANCE, SERVICE, & Support ONE Year Limited Warranty One Year Limited Warranty Regulatory Information Purchase Record Contact Information