Atek electronic OnBoard manual Closing the keyboard

Page 18

Setup

Closing the keyboard

When you are done using the keyboard, wrap the cord around the post on the bottom left corner of the keyboard first, then around the two on the right side, and then push the connector into the nesting area where you will find it fits snuggly.

Ctrl

Shift

Esc

! 1 Tab

Q CapsLock

A

S

Z

X

Alt

F1

 

@

F2

2

#

 

3

W

 

 

E

D

 

 

F

C

 

F3

$ 4

R

When you wrap the cord around each post, gently pull some of the slack out of the cord so that it does not sag too much over the side of the keyboard and so that the connector reaches well into the nesting area. For proper sliding action, nest the connector as close to the far left side of the nesting area as possible.

OnBoard User’s Manual, Page 17

Image 18
Contents Page Need HELP? Health & Safety Information Table of Contents Introduction Compatibility & System Requirements Features Number of KeysSize and position of non-crucial keys Numeric keypad closer to main part of keyboardOverall Size Features Features Features Features Tilt Special CordSpecially Protected Characters Setup Opening the keyboardAlt Post Tab Closing the keyboard Push cord into groove Cover Installation Troubleshooting Problem Keyboard does not WorkTroubleshooting Troubleshooting Possible Cause Bad connection Troubleshooting MAINTENANCE, SERVICE, & Support ONE Year Limited Warranty One Year Limited Warranty Regulatory Information Purchase Record Contact Information