AMX PC Presenter Pre-Installation, Setting the TXC-MSL transmitter DIP switch, IR and RF Settings

Page 11

Pre-Installation

Pre-Installation

Setting the TXC-MS(L) transmitter DIP switch

The TXC-MS(L) transmitter transmits IR or RF signals, according to how you set position 1 on the 8-position DIP switch. The DIP switch is located under the battery cover, on the back of the TXC-MS(L), as shown in FIG. 6. To open the battery compartment, slide the cover down and remove.

8-position DIP switch

Battery compartment

FIG. 6 Location of 8-position DIP switch and battery compartment locations

FIG. 7 shows the eight-position transmitter DIP switch.

DIP switch #1	DIP switches
sets IR or RF	#2 - 4 are not used
transmission

DIP switches

#5 - 8 set the radio code of the transmitter

FIG. 7 Eight-position transmitter DIP switch

IR and RF Settings

The transmitter can be configured for either IR or RF, but not both. DIP switch position 1 sets the transmitter for IR or RF, as shown in FIG. 8.

IR mode

RF mode

FIG. 8 DIP switch settings for IR and RF modes

Set position 1 to Off (down) for IR.

Set position 1 to On (up) for RF.

PC Presenter	7

Image 11

Contents PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units IntroductionTXC-MSL Transmitter TXC-MSL SpecificationsTXC-MSL mouse controls Trigger switchTXC-MSL controls Front Panel AXR-MSE Wireless Mouse and Keyboard ControllerAXR-MSE Specifications Keyboard IN/OUT Rear PanelIntroduction IR and RF Settings Pre-InstallationSetting the TXC-MSL transmitter DIP switch Radio codes DIP switch positions Channel code ranges From Radio Code SettingsSetting radio codes TXC-MSL pushbutton configuration Setting the Device DIP switchPosition Using the PC Presenter Without a PC ComputerDevice DIP switch positions and values SW3 SW2 Wiring Requirements Setting Mouse ModeWire size Wiring guidelinesWiring Guidelines Preparing captive wiresPre-Installation Connecting the AXR-MSE to the PC mouse and PC Installing the PC PresenterInstalling the PC Presenter for Stand Alone Operation Connecting the AXR-MSE to the PC keyboard and PCAXlink data and 12 VDC power supply connections Installing the PC Presenter for AXlink OperationUsing AXlink for data and power LED indicators Installing the PC Presenter Programming the PC Presenter Programming the PC Presenter in Stand Alone ModeUsing PC Presenter Commands Short form listing of keycodes List commands HelpClear memory Display version and copyright info Programming Transmitter PushbuttonsDisplay available memory Long form list of stored keycodesExiting program mode Creating a buffer for keyboard input SendCommandsSendCommands TXIDn SendStringsSendStrings RMACROn-sChannel Direction Speed Mouse Control ChannelsMouse Control Channels Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving ProgramUsing the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery ReplacementAMX reserves