AMX instruction manual Introduction, PC Presenter transmitter and receiver units

Page 5

Introduction

Introduction

The PC Presenter PC is a wireless PC keyboard and mouse controller that can be used as a standalone unit or as an bus device connected to a Central Controller via AXlink; controlling PC keyboard and mouse functions, and devices connected to the AXlink bus.

The PC Presenter transmitter is available with a built-in laser pointer (TXC-MSL), or without the laser pointer (TXC-MS).

The PC Presenter (FIG. 1) consists of a TXC-MS(L) wireless transmitter and an AXR-MSE Wireless Mouse and Keyboard Controller (receiver/processor). The TXC-MS(L) transmitter has mouse controls and can be equipped with up to 24 pushbuttons with an engraved overlay. Each pushbutton performs a specific operation according to the Axcess software in your AMX control system, and the mouse disc and buttons control PC mouse functions. The TXC-MS(L)'s cordless hand-held design lets you interact with your audience and your computer with convenience and comfort.

TXC-MS(L) transmitter

AXR-MSE Wireless Mouse and Keyboard

Controller (receiver/processor)

FIG. 1 PC Presenter - transmitter and receiver units

The PC Presenter can be used in stand-alone or AXlink mode. The PC Presenter can control a PC keyboard and mouse functions, plus any devices connected to the AXlink bus.

The PC Presenter can also be used in RF or IR control mode. Set the control mode by setting the transmitter DIP switch (refer to the Setting the TXC-MS(L) transmitter DIP switch subsection). IR applications require an external IR sensor (IRX-DM+ or IRX-SM+) configured for 455 KHz operation.

PC Presenter

1

 

 

 

 

Image 5
Contents PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units IntroductionTXC-MSL Transmitter TXC-MSL SpecificationsTXC-MSL mouse controls Trigger switchTXC-MSL controls Front Panel AXR-MSE Wireless Mouse and Keyboard ControllerAXR-MSE Specifications Keyboard IN/OUT Rear PanelIntroduction IR and RF Settings Pre-InstallationSetting the TXC-MSL transmitter DIP switch Radio codes DIP switch positions Channel code ranges From Radio Code SettingsSetting radio codes TXC-MSL pushbutton configuration Setting the Device DIP switchPosition Using the PC Presenter Without a PC ComputerDevice DIP switch positions and values SW3 SW2 Wiring Requirements Setting Mouse ModeWiring Guidelines Wiring guidelinesPreparing captive wires Wire sizePre-Installation Installing the PC Presenter for Stand Alone Operation Installing the PC PresenterConnecting the AXR-MSE to the PC keyboard and PC Connecting the AXR-MSE to the PC mouse and PCAXlink data and 12 VDC power supply connections Installing the PC Presenter for AXlink OperationUsing AXlink for data and power LED indicators Installing the PC Presenter Programming the PC Presenter Programming the PC Presenter in Stand Alone ModeUsing PC Presenter Commands Short form listing of keycodes List commands HelpClear memory Display available memory Programming Transmitter PushbuttonsLong form list of stored keycodes Display version and copyright infoExiting program mode Creating a buffer for keyboard input SendCommandsSendCommands SendStrings SendStringsRMACROn-s TXIDnChannel Direction Speed Mouse Control ChannelsMouse Control Channels Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving ProgramUsing the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery ReplacementAMX reserves