AMX PC Presenter instruction manual LED indicators

Page 21

Installing the PC Presenter

Make sure to connect only the GND wire on the AXlink connector when using a 12 VDC power supply. Do not connect the PWR wire to the AXlink connector's PWR opening.

LED indicators

When the AXR-MSE is powered up, the front panel LEDs light to indicate the status of the unit as

described below:

All LED's lighting sequentially from left to right indicates that the AXR-MSE

firmware is loaded and running.

Blinking pattern that alternates between the Mouse + Data LED's and the Keyboard LED indicates that the AXR-MSE is running on boot code only, and has no downloaded program. You must download program code to operate the AXR-MSE.

PC Presenter	17

Image 21

Contents PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units IntroductionTXC-MSL Transmitter TXC-MSL SpecificationsTrigger switch TXC-MSL controlsTXC-MSL mouse controls AXR-MSE Wireless Mouse and Keyboard Controller AXR-MSE SpecificationsFront Panel Keyboard IN/OUT Rear PanelIntroduction Pre-Installation Setting the TXC-MSL transmitter DIP switchIR and RF Settings Radio Code Settings Setting radio codesRadio codes DIP switch positions Channel code ranges From TXC-MSL pushbutton configuration Setting the Device DIP switchUsing the PC Presenter Without a PC Computer Device DIP switch positions and valuesPosition SW3 SW2 Wiring Requirements Setting Mouse ModeWiring Guidelines Wiring guidelinesPreparing captive wires Wire sizePre-Installation Installing the PC Presenter for Stand Alone Operation Installing the PC PresenterConnecting the AXR-MSE to the PC keyboard and PC Connecting the AXR-MSE to the PC mouse and PCInstalling the PC Presenter for AXlink Operation Using AXlink for data and powerAXlink data and 12 VDC power supply connections LED indicators Installing the PC Presenter Programming the PC Presenter in Stand Alone Mode Using PC Presenter CommandsProgramming the PC Presenter List commands Help Clear memoryShort form listing of keycodes Display available memory Programming Transmitter PushbuttonsLong form list of stored keycodes Display version and copyright infoExiting program mode SendCommands SendCommandsCreating a buffer for keyboard input SendStrings SendStringsRMACROn-s TXIDnMouse Control Channels Mouse Control ChannelsChannel Direction Speed Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving ProgramUsing the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery ReplacementAMX reserves