AMX PC Presenter instruction manual SW3 SW2

Page 15

Pre-Installation

SW3

SW2

Top front view

FIG. 11 AXR-MSE internal circuit board showing the location of the SW2 and SW3 slide switches

FIG. 12 shows a close-up view of the SW2 and SW3 internal slide switches.

SW3

PS2 mouse

SW2

NO

PC

Serial mouse

PC

FIG. 12 Close-up view of SW2 and SW3 internal slide switches

1.Discharge the static electricity from your body and the screwdriver.

2.Unplug all connectors from the rear panel of the AXR-MSE.

3.Remove the four Phillips-head screws on the sides of the enclosure.

4.Remove the cover.

5.Set the AXR-MSE switch SW2 for use without a CPU as follows:

For keyboard use without a PC, slide the SW2 switch to the "NO PC" position shown in FIG. 13.

SW2

NO

PC

PC

FIG. 13 Switch setting for keyboard use without PC connected

PC Presenter

11

 

 

 

 

Image 15
Contents PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units IntroductionTXC-MSL Transmitter TXC-MSL SpecificationsTrigger switch TXC-MSL controlsTXC-MSL mouse controls AXR-MSE Wireless Mouse and Keyboard Controller AXR-MSE SpecificationsFront Panel Keyboard IN/OUT Rear PanelIntroduction Pre-Installation Setting the TXC-MSL transmitter DIP switchIR and RF Settings Radio Code Settings Setting radio codesRadio codes DIP switch positions Channel code ranges From TXC-MSL pushbutton configuration Setting the Device DIP switchUsing the PC Presenter Without a PC Computer Device DIP switch positions and valuesPosition SW3 SW2 Wiring Requirements Setting Mouse ModeWire size Wiring guidelinesWiring Guidelines Preparing captive wiresPre-Installation Connecting the AXR-MSE to the PC mouse and PC Installing the PC PresenterInstalling the PC Presenter for Stand Alone Operation Connecting the AXR-MSE to the PC keyboard and PCInstalling the PC Presenter for AXlink Operation Using AXlink for data and powerAXlink data and 12 VDC power supply connections LED indicators Installing the PC Presenter Programming the PC Presenter in Stand Alone Mode Using PC Presenter CommandsProgramming the PC Presenter List commands Help Clear memoryShort form listing of keycodes Display version and copyright info Programming Transmitter PushbuttonsDisplay available memory Long form list of stored keycodesExiting program mode SendCommands SendCommandsCreating a buffer for keyboard input TXIDn SendStringsSendStrings RMACROn-sMouse Control Channels Mouse Control ChannelsChannel Direction Speed Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving ProgramUsing the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery ReplacementAMX reserves