AMX PC Presenter instruction manual Using the OLDesign Engraving Program

Page 31

Using the OLDesign Engraving Program

Using the OLDesign Engraving Program

The AMX OLDesign software program is a Windows-based design tool for creating panel overlays, pushbutton names, and pushbutton operation descriptions. The operation descriptions are used when the Axcess operating software is programmed. OLDesign also contains an online help system that describes producing custom overlay designs and pushbutton descriptions, and then storing them on your computer. FIG. 20 shows the OLDesign main window and a sample TXC-MS overlay design. Refer to the OLDesign for Windows Quick Reference Guide for command instructions that can be used with the OLDesign online help system.

FIG. 20 OLDesign main window with example TXC-MS overlay

PC Presenter	27

Image 31

Contents PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units IntroductionTXC-MSL Transmitter TXC-MSL SpecificationsTXC-MSL controls Trigger switchTXC-MSL mouse controls AXR-MSE Specifications AXR-MSE Wireless Mouse and Keyboard ControllerFront Panel Keyboard IN/OUT Rear PanelIntroduction Setting the TXC-MSL transmitter DIP switch Pre-InstallationIR and RF Settings Setting radio codes Radio Code SettingsRadio codes DIP switch positions Channel code ranges From TXC-MSL pushbutton configuration Setting the Device DIP switchDevice DIP switch positions and values Using the PC Presenter Without a PC ComputerPosition SW3 SW2 Wiring Requirements Setting Mouse ModeWire size Wiring guidelinesWiring Guidelines Preparing captive wiresPre-Installation Connecting the AXR-MSE to the PC mouse and PC Installing the PC PresenterInstalling the PC Presenter for Stand Alone Operation Connecting the AXR-MSE to the PC keyboard and PCUsing AXlink for data and power Installing the PC Presenter for AXlink OperationAXlink data and 12 VDC power supply connections LED indicators Installing the PC Presenter Using PC Presenter Commands Programming the PC Presenter in Stand Alone ModeProgramming the PC Presenter Clear memory List commands HelpShort form listing of keycodes Display version and copyright info Programming Transmitter PushbuttonsDisplay available memory Long form list of stored keycodesExiting program mode SendCommands SendCommandsCreating a buffer for keyboard input TXIDn SendStringsSendStrings RMACROn-sMouse Control Channels Mouse Control ChannelsChannel Direction Speed Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving ProgramUsing the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery ReplacementAMX reserves