Webbing the L60

Fig 16

1.Turn off the Main Power switch (22) on the Front Panel

2.Loosen the black thumbscrew (19).

3.Slide off the removable label retainer (20).

4.Place a roll of labels on the Unwind Hub (01).

5.Loosen the Socket Head Cap Screw (02) on the Clamp of the Unwind Backing Disc (03) and position the roll of labels so the labels track centered on the Vacuum Head (06) when peeled off (See FRONT VIEW). (NOTE: For round or oval labels, it is important that the Star Wheel (05) be on the centerline of the label).

6.NOTE: If the unit is equipped with photoelectric label sensing or a clear label sensor, the position of the sensor relative to the label is not critical in most cases. The clear label sensor detects the difference in thickness from the label to the backing material. Metalized graphics or alphanumeric characters will cause this sensor to false trigger. Locate the sensor away from the path of metalized material. (See SIDE VIEW PHOTO SENSOR)

7.Replace the removable label retainer (20) and tighten thumbscrew (19).

8.Pull the web over the Brake Arm (06) and down between the Web Guides (07) on the Label Guide Support Plate (08). (NOTE: If equipped with photoelectric sensor, slide web between white idler roller and web drag (21).

9.Adjust the Web Guides (07), so the web is held with minimum side play but still moves freely.

Page 17