10.Pull the web under the Star Wheel and down between the first Idler Roll (09) and the Label Guide Support Plate (08), then forward over Idler Roll (10) and under Idler Roll (11).
11.NOTE: There are 2 Web guides located here also. Adjust them as above in Step 8.
12.Next, pull the web between the Peeler Plate (12) and the Web Drag (13).
13.Pull the web until approximately 18” extends from the peeler plate, Remove any labels that are on this part of the web.
14.Bring the web back between the Peeler Plate (12) and Air Assist Tube (14), under Idler Roll (10) then up around the Drive Roller (15).
15.Push the Drive Roller (15) away from the Nip Roller (16).
16.Slide the web between the Nip Roller (16) and Drive Roller (15), under the Web
17.Secure the web around the Rewind Spool using Web Retention Clip (23) and turn the Rewind Spool until the web is held firmly. This may require pulling even more web, which will peel off some labels. Catch these labels so they don’t stick on something.
18.Grasp the Rewind Spool and turn it counterclockwise for Right Hand, or clockwise for Left Hand to take up slack in the web.
19.Loosen the thumbscrew on the Web Drag Assembly (13) and apply moderate pressure by lifting up on the thumbscrew, forcing the thin Web Drag Plate down on the labels. This will keep the label from buckling as it is fed onto the vacuum head.
Page 18