Universal manual Setupand Operation, Assembling the L60

Page 8

SECTION 2 SETUPAND OPERATION

ASSEMBLING THE L60

Using a square, mount the Unwind Assembly to the back of the L60 using the 2 screws provided. The top screw is a ¼-20x1-1/2” socket head cap screw, the bottom screw is ¼-20x1-1/4”.

Please note: Screws. Top one is longer.

Fig 3

Maximum reliability is assured when the Compressed Air supplied to the L60 is Clean & Dry. Over time, moisture will take its toll on the Solenoid Valves and Air cylinder. Also it is not recommended to add Oil to the Compressed Air line supplied to the L60. The air valves and air cylinder will eventually fail and oil will end up on the label from the Air Assist tube which helps feed the label on to the vacuum head. This will cause the label to not adhere properly to the product.

Run 40 psi @5CFM minimum compressed air to the L60 and procure necessary fittings to make the connection to the air inlet located on the side opposite the label drive and rewind. DO NOT CONNECT THE AIR TO THE UNIT AT THIS TIME.

Page 8

Image 8

Contents L60 Operator’s Manual Version D 12/18/2001 Universal Labeling Systems, IncTable of Contents Overview IntroductionUN-PACKING Instructions Product Warranty Performance GuaranteeSpecifications Setupand Operation Assembling the L60Function of Unwind Assembly Waste Removal Mounting the L-60 Theory of Operation Adjusting the Lower Hall Effect Sensor Lower Hall Effect Sensor OptionalSmart Head Optional Explanation of Label Transfer Adjusting the Air Assist Tube air pressure Air Assist TubeWebbing the L60 Page Running the L60 Star Wheel Adjustment Procedures Label Sensing Star WheelData Logic Sensor Optional Setup Procedure Lion Sensor OptionalMaintenance Starwheel MaintenanceGeneral Maintenance Symptom SolutionDrive Roll fails to Stop when star wheel turns over Drive Roll does not START, check the followingPage #05 ProblemL60-I-30D #29 Problem Vacuum Head Fundamentals Variables Affecting Vacuum Head PerformanceTechnical Support Drawings and Bill of Materials Bill of Material L60 Label ApplicatorPage ASSEMBLY, Front Side Panel Page ASSEMBLY, Rear Side Panel Page ASSEMBLY, Rear Side Page ASSEMBLY, Belt Tensioner Page ASSEMBLY, Tamp ASSY. Prox Sensor W/ ConnectorPage ASSEMBLY, Blow Page ASSEMBLY, Gauge Page ASSEMBLY, Front Panel Page ASSEMBLY, Front Panel PLC Page ASSEMBLY, Guide Page ASSEMBLY, Valve Page ASSEMBLY, R. H Unwind WASHER, 5/16 FW SSPage Page Page Page ASSEMBLY, Lion EYE Optical Label Sensor Page ASSEMBLY, Data Logic Optical Label Sensor Page L60 Tamp or BLOW-ON Applicator Page Page Page