TROUBLESHOOTING (continued)
1.Is machine receiving power from power source? Check the outlet with a voltmeter.
2.Are all electrical connections in place and tight?
3.Does motor and drive train turn freely? (Turn machine off and turn drive roll by hand.)
4.Is machine webbed correctly? (Check webbing diagram)
5.Are drive roll and star wheel clean and operating properly?
6.Is any wiring frayed, chafed, or broken?
7.Is Belt Tensioner Assembly at correct tension? (Taunt)
8.Are adjusting screws and studs tight?
9.Are pulleys tight on shafts? Tighten set screws carefully avoid stripping threads. And /or Allen wrench receptacle.
Page 27