Section 4: Using the Control Panel
The Control Panel can be used to start and stop dispensing of labels, display label counts and other advanced functions.
Start/Stop Button: Starts or stops the motor depending on whether or not the label sensor is tripped. Note: If sensor does not get triggered in a 24” run, the motor will stop.
a.If the motor is in Stop Mode the display flashes. Otherwise the display is on solid.
b.If held for 2 seconds it will toggle the label counter between Decrement and Increment Mode as indicated by the lower right decimal point. If the decimal point is on, the label counter is in Decrement Mode.
Counter Reset Button: Pressing this button will reset the label counter if held for 2 seconds.
Start/ | Counter | + | - |
Stop | Reset |
+Button: Pressing this button for 2 seconds will increase the label counter. It will repeat advance if held.
-Button: Pressing this button for 2 seconds will decrease the label counter. It will repeat advance if held.
Special Setup Modes:
1.To set the LED Display Intensity: Press and hold the Start/Stop Button and the + Button until the display changes to “LED”. Then press the + or – buttons to adjust the LED intensity.
2.