Primera Technology DX850 quick start Unpacking and Setup

Section 1: Unpacking and Setup

Thank you for purchasing the DX850 Label Dispenser (hereafter referred to as "Label

Dispenser").

The Label Dispenser includes a Power Cord, 12 volt Power Adapter and the parts shown in Figure 1-1.The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along with the Power Cord. You will need to assemble them as shown in Figure 1-1 and 1-2.Also see Section 2 for more detailed instructions on assembling these parts. Attach the Power Cord and switch on the power as shown in Figure 1-2. Finally, remove the foam insert between the Liner Idler Roller and Liner Drive Roller.

Figure 1-1.

Guide Roller	Label Sensor	Roll Guides
Liner Drive Roller		Roll Bar
Liner Idler Roller
Liner Idler Roller Tab

Control Panel

Label Sensor Bracket

Peel Edge

Figure 1-2.

Power Adapter	Roll Guides
	Roll Bar

Power Switch	Power Adapter	Roll Drag Arm
Power Input 12V	Power Cord

DX850 Label Dispenser 3