Primera Technology DX850 quick start Dispensing the Label, Less than Label Height

Section 3: Dispensing the Label

To dispense a label, first load label stock as described in Section 2, connect power and switch on the Label Dispenser. Follow these steps to dispense labels.

1.Before you start dispensing you should adjust the Label Sensor on the Label Sensor Bracket so that the distance between the Label Sensor and the Peel Edge is equal to roughly 1/2” less than the label height. (Figure 3-1.)

Figure 3-1.

1/2" less than Label Height

For example, for a 4" wide x 2" high (101.6mm x 50.8mm) label you would set this distance to approximately 1-1/2” (38.1 mm). The exact distance is not critical. It is only important that you set the distance so that the label does not come off the liner when presented. If the label height dictates the sensor be moved beyond the available travel, set the sensor to the minimum or maximum position as applicable.

2.To Start dispensing press the Start/Stop button on the Control Panel. (Figure 3-2.)

Figure 3-2.

Start/	Counter	+	-
Stop	Reset

DX850 Label Dispenser 9