Primera Technology DX850 quick start Liner Idler Roller positions

6.Now position the stock to correspond with the general area where the labels will be dispensed.

7.Pull the loose end of the label stock forward under the Top Roller. Pull approximately 6 inches of label stock out beyond the Peel Edge. (Figure 2-5.)

Figure 2-5.

Tip! See Section 5 for a Label Path diagram.

8.Take the loose label stock and feed it between the Liner Idler Roller and the Liner Drive Roller. (Figure 2-6.)In order to feed the label stock between the rollers, the Liner Idler Roller should be in the unclamped position. (See Figure 2-10 for a detailed diagram of the

Liner Idler Roller positions.)

Figure 2-6.

Note: This procedure assumes that the first 6 inches of labels will not be dispensed using the Label Dispenser. Of course, you may still peel these labels by hand.

6 DX850 Label Dispenser