Precautions when Installing

Digital Multiplexer

• Be sure to turn the unit off before installing.

• Avoid shock or vibration since they may cause unit malfunction.

• Keep away from magnets, radio or TV to avoid magnetic damage.

• During or after installing the unit, be sure to maintain the area around the unit clean.

• Place the unit on a flat surface and maintain temperature	15Cm
• Place the unit on a flat surface and maintain temperature
properly. Allow 15 cm of clearance between the rear
panel and the wall.

• Be careful not to drop any conductive materials into the hole for ventilation

ENGLISH

2-2

Page 11

Image 11

Samsung SDM-090P, SDM-160MP, SDM-160P manual Precautions when Installing

Contents

Digital Multiplexer Important Safeguards Iii Contents Appendix B Checking Points in Trouble Introduction Introduction Name of parts and Function Move → Rear panel Physical & Environmental Preparing for the Installation Precautions when Installing Digital Multiplexer Unpacking Connecting to S-VHS VCR and S-VHS Monitor Connecting to Other DevicesConnecting to normal VCR and Monitor Connecting to Time Lapse VCR Connecting to Alarm Sensor Ascii Remote Control by connecting to PC Spot OUT Control Remote Control using SSC-1000RS-485Monitor OUT Control @ Spot OUT Control Initial operation When desiring to see in the live screen/replay screenWhen desiring to see in the Triplex screen Basic Method to use When desiring to see in the division screen When desiring to see in the Full screen When desiring to see automatic sequential conversion screen Full Mode 2TIMES Zoom Times Zoom When desiring to see the stop screenWhen desiring to see in the zoom screen When desiring to see output of VCR as it is When desiring to see in the PIP screenWhen desiring to see in the record screen Duty SET Reservation OFF Setting of Program MenuRecord setting of each camera REC OUT SET Type TLV END Time REC Duty SET CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9REC Reservation Start Time PB Display ALL Spot OUT Cvbs PIP Size Setting of display modeSequence Loss Detect Loss Info Alarm Info Motion Info ALL Sequence Alarm S/W Time CH15 on Setting of title by channel DATE/TIME SET Display Type Title SETIjklmnopqrstuvwxyz Setting of motion Setting of alarm Motion OUT OFF ↔ on List Update OFF ↔ onXxxxx Sensitivity OFF ↔ LOW ↔ Medium ↔ High Baud Rate System settingPassword Change Password Check OFF Alarm Buzzer Loss Buzzer Summer Time +++++++++++++++++ + - - - - + Password Change Password Check NEW Password Confirm Recording Normal record modeTime Lapse record mode REC Duty Weight value REC Duty recordAlarm weight value record Reservation record Alarm signal standard Alarm occurrence conditionsAlarm release Alarm record Operation in motion detection Alarm/Loss list referenceOperation in video loss Image input Appendix a Specifications Outside Drawing Appendix B Checking points in trouble When record is not done