Digital Multiplexer
-The following screen is displayed if pressing the “ENTER” button when the blinking position is at the “PASSWORD CHANGE…”:
[PASSWORD CHANGE]
PASSWORD CHECK
- - - - - - - -
NEW PASSWORD
- - - - - - - -
CONFIRM
- - - - - - - -
ENGLISH
•The password in shipment from factory is “12345678”.
•The first digit from the initial password check blinks.
Press the current password in order of “1” ~ “10” of the “camera select” button. “10” is considered as “0”.
•The first digit of the new password blinks if properly entering the password check as per the current password.
•Enter 8 characters of the new password to set using the “1” ~ “10” of the “camera select” button.
•Enter a new password once again from the CONFIRM.
•Message of “ERROR TRY AGAIN” is displayed on the bottom of screen if a password entry error occurs and changed the password again in the above method. Turning it by more than 3 times will completely escape from the setup menu.
•The changed setting value is stored if pressing the “SET” button and you can return to the main menu.
✴ “X” is displayed on screen when entering password.
-Password check
The following screen is displayed if the “password check” turns “ON” when entering to the setup menu:
PASSWORD CHECK
+++++++++++++++++
+ - - - - - - - - +
+++++++++++++++++
Enter the current password in order.
Enter into the setup menu (main menu) if the current password is proper.
Return to the previous status if the password is wrong more than 3 times.
✴“X” is displayed on screen when entering password.