DSP setup page:
Figure 7.2: DSP matrix mixer GUI setup screen
– Input level control (iPad, +48V, HPF).
– Input DRC – Dynamic Range Compression.
– Input Parametric EQ (Mic./Line 5 bands, Line inputs 3 bands).
– Assign.
– Crossover (8th order).
– Output Zone EQ (7 bands).
– Delay.
– DRC- Dynamic Range Compression.
– Output level Control.
– Output assignment.
Other DSP matrix mixer configurations in the GUI:
– Priority set up.
– Ducking levels.
– Password set up.
– Call station set up.
See also
–Troubleshooting, page 41
Multi Channel DSP Amplifier PC GUI
All DSP features for the multi channel DSP amplifier are controlled via the PC software GUI.
With the amplifier PC GUI: fault monitoring can be viewed and DSP features can be configured
or controlled via the connected PC.
Notice!
Unlike the DSP matrix mixer, the amplifiers can work as a basic amplifier (i.e. without the use
of the DSP features). Level controls for each amplifier channel are on the rear of the unit.
Refer to PC GUI software, page 16 installation to install the PC GUI, if needed.
Proceed as follows:
Notice!
Changes and updates to this procedure are available in the software down load file.
7.5
28 en | Configuration PLENA matrix
2013-06 | V1.0 | Operation manual Bosch Security Systems B.V.