32 en Operation

PLENA matrix

 

 

8Operation

Call stations and wall control panels can only operate when connected to the DSP matrix mixer and individual IDs have been set via the DIP switches on the units. Refer to Call Station DIP switch settings, page 23 and Wall Control Panel DIP switch settings, page 24.

The multi channel DSP amplifier can operate both as a standalone amplifier or connected to the DSP matrix mixer.

8.1Start

1.Check that all connections have been made to relevant units in the system including wall control panels and call stations.

2.Power on the DSP matrix mixer followed by the amplifiers.

3.Check that the power LED are illuminated on the front of the DSP matrix mixer and amplifier(s) (19” rack unit(s)).

4.Check that the RS485 LED is flashing for connections to the wall control panels and call stations.

5.Make sure that the level controls on the rear of the amplifier are set to the desired level.

6.For use with the PC GUI software, Click “Device” from the menu bar, and then “Connect”. Refer to PC GUI software, page 16.

If the above steps have been followed the system should be in its last mode of operation. However, if this is the initial powerup of the system, it will be obviously be in its factory default state.

If all of the above steps have been followed and the system is not working correctly, refer to the Troubleshooting, page 41 section of this manual.

Continue with one of the following chapters:

Call Station, page 33

Wall Control Panel, page 35

Multi Channel DSP Amplifier, page 37

DSP Matrix Mixer, page 39

2013-06 V1.0

Operation manual

Bosch Security Systems B.V.

Page 32
Image 32
Bosch Appliances V1.0 operation manual 8Operation, 1Start, Continue with one of the following chapters