RS232 Communications Protocol & Command Set (continued)
Request Input Voltage Level
Transmit the input AC voltage status
Send to UPS: | ?INPUTVOLTS<CR> |
Response from UPS: | XXX<SP>VAC<SP>IN<CR> |
| XXX is the input AC voltage represented |
| in ASCII. |
Request Output Voltage Status
Transmit the output voltage state
Send to UPS: | ?OUTPUTSTAT |
Response from UPS: | XXX<SP>VAC<SP>OUT<CR> |
| XXX is the output voltage represented |
| in ASCII. |
If the UPS is not in AVR or BATTERY mode:
Response from UPS: NORMAL<CR>
If the UPS is in AVR mode and boosting voltage by 13%
Response from UPS: AVRBOOST1<CR>
If the UPS is in AVR mode and boosting voltage by 26%
Response from UPS: AVRBOOST2<CR>
If the UPS is in AVR mode and bucking voltage by 11%
Response from UPS: | AVRBUCK1<CR> |
If the UPS is in BATTERY mode | |
Response from UPS: | BATTERY<CR> |
Request Load Level Status
Transmit the load level percentage.
Send to UPS: | ?LOADSTAT<CR> |
Response from UPS: | XX<SP>%LOAD<CR> |
| XX is the load percentage represented |
| in ASCII. |
Request Battery Charge Level Status
Transmit the remaining battery charge percentage.
Send to UPS: | ?BATTERYSTAT<CR> |
Response from UPS: | XX<SP>%BATTERY<CR> |
| XX is the battery charge percentage |
| represented in ASCII. |
Identify Equipment
Transmit the model number, firmware number and revision.
Send to UPS: | ?ID<CR> | |
Response from UPS: | PANAMAX<CR> | |
| ||
| FW<SP>PARTNUMBER<CR> | |
| REV<SP>REVISION<CR> | |
List all Commands and Queries |
| |
| ||
Send to UPS: | HELP<CR> | |
Response from UPS: | MAIN_ON<CR> | |
| MAIN_OFF<CR> | |
| NCL_ON<CR> | |
NCL_OFF<CR>
BATTHRESH<CR>
BEEPON<CR>
BEEPOFF<CR>
RESTORE<CR>
?OUTLETSTAT<CR>
?INPUTVOLTS<CR>
?OUTPUTSTAT
?LOADSTAT<CR>
?BATTERYSTAT<CR>
?ID<CR>
HELP<CR>
USA & Canada (800) |
| 15 |