Transcend Information TS-USL3, TS-USP3/N Drive A/Drive B, Floppy Mode 3 Support, Video, Halt On

BIOS SETUP 29

•Precomp: Write precompensation cylinder

•Landing Zone: Landing zone

•Sector: Number of sectors

•Drive A/Drive B

Select the correct type of diskette drive(s) installed in the computer.

-None: No diskette drive installed

-360K, 5.25 in.: 5-1/4-inch standard drive; 360 kilobyte capacity

-1.2M, 5.25 in.: 5-1/4-inch high-density drive; 1.2 megabyte capacity

-720K, 3.5 in.: 3-1/2-inch double-sided drive; 720 kilobyte capacity

-1.44M, 3.5 in.: 3-1/2-inch double-sided drive; 1.44 megabyte capacity

-2.88M, 3.5 in.: 3-1/2-inch double-sided drive; 2.88 megabyte capacity

•Floppy Mode 3 Support

Supports some particular Japanese floppy drives (3-1/2-inch drive with 1.2 megabyte capacity).

•Video

Select the type of primary video subsystem in your computer. The BIOS will detect the correct video type automatically. The BIOS supports a secondary video subsystem, but do not select it in this Setup.

-EGA/VGA: Enhanced Graphics Adapter/Video Graphics Array. For EGA, VGA, SEGA, SVGA or PGA monitor adapters.

-CGA 40: Color Graphics Adapter, powers up in 40-column mode.

-CGA 80: Color Graphics Adapter, powers up in 80-column mode.

-MONO: Monochrome adapter, including high resolution.

•Halt On

During POST, the computer stops if the BIOS detects a hardware error. You can set the BIOS to ignore certain errors during POST and continue the boot-up process. The followings are the selections:

-All Errors: If the BIOS detects any non-fatal errors, POST stops and prompts you to take corrective action.

-No Errors: POST does not stop for any error.

-All, But Keyboard: If the BIOS detects any non-fatal errors except keyboard, POST stops and prompts you to take corrective action.