Quick Configuration
Required and | You must configure the following network settings of the |
optional | Environmental Monitoring Unit before it can function on a |
settings | network. |
| • IP address of the unit |
| • Subnet Mask |
| • IP address of the Default Gateway |
| No further configuration is required. The remaining properties |
| of the unit have default settings. However, you may want to |
| customize settings for your application. See “Managing the |
| Unit” in the User’s Guide (usrguide.pdf). |
Configuring | Choose the configuration method that matches your |
TCP/IP settings | environment: |
| • If you are using Windows 95, Window 98, or Windows |
| NT, see “Through the Management Card Wizard” on |
| this page. |
| • If you are not using a |
| you require direct serial configuration, see “Serially |
| through the Control Console” on page 12. |
| • If you are a network administrator using a computer |
| connected to the local subnet, see “Over the Network by |
| ARP” on page 13. |
| • If you are a network administrator using BOOTP, see |
| “Over the Network by BOOTP” on page 13. |
| Through the Management Card Wizard. The |
| Environmental Monitoring Unit contains a management card |
| that provides the network interface. On a Windows 95, |
| Windows 98, or Windows NT 4.0 workstation, the |
| Management Card Wizard provides a quick way to configure |
| all management card settings, including TCP/IP settings. To |
| access the Management Card Wizard, run the program |
| setup.exe on the |
| the |
| Continued on next page |
11