APC AP9810, AP9613 manual Name Description

Item	Name		Description
	Universal I/O	These support the AP9335T/ TH and AP9810 dry
	ports 1 and 2	contact accessories
	USB cable	Connecting this to your PC enables usage of the
	connector	Configuration Utility.
	Reset button	Use an appropriately sized, non-metallic tool to
		press the Reset button.
		Holding the button for 5 seconds reboots the Card.
		Holding the button for 25 seconds resets the Card to
		the factory defaults. (The status light flashes green
		when you do this).
	Status indicator	•	SOLID GREEN indicates communications and
		•	operations are fine
			FLASHING GREEN indicates the Card is
		•	initializing
			FLASHING RED indicates a communication fault
		•	SOLID RED indicates a non-operational fault
	Dip switches	These are located near the back of the front panel on
		the right-hand side. See the “Location of dip
		switches” and “Configuring the Dip Switches”
		sections.
	Output relay	Connections for alarm outputs.
	terminals	See “Itemizing the input contact and output relay
		terminal blocks” and “Ratings for input contacts and
		output relays” .
	Input contact	Connections for control inputs.
	terminals	See “Itemizing the input contact and output relay
		terminal blocks” and “Ratings for input contacts and
		output relays” .
	Cord grip	Supports the cabling that is used to control external
		devices, or to connect up external switches. The

bare wires connect to the terminal blocks on the Card.

The cord grip is plastic and can secure a single cord with a diameter range of 5.8 – 10mm. This limits the number of conductors (inside the cord) and the power ratings.

Dry Contact I/O SmartSlot Card 5