Introduction/Before Installation
Introduction/Before Installation
About this Manual
The APC
This manual describes procedures on how to properly unpack and install the UPS, connect the battery and equipment, configure accessories, and start up the system.
Illustrations are representative. Your configuration, including components and optional APC equipment, may be different from the models shown in this manual. The user manual is accessible from the supplied CD and the APC Web site, www.apc.com.
Contact Information
Refer to www.apc.com to contact APC or for additional information about this product.
Safety Information
Warning
Read the Safety Guide before you begin the installation, operate the UPS, or perform equipment maintenance. Failure to comply with safety instructions could result in bodily injury or equipment damage.
Unpacking and Equipment Placement
The UPS is heavy. Two people are required to lift the UPS.
Select a location sturdy enough to handle the weight of the UPS.
1.Unpack the equipment. The packaging is recyclable; save it for reuse or dispose of it properly.
2.Inspect the equipment upon receipt. Notify the carrier and dealer if there is damage.
3.Check the package contents:
•UPS and front bezel
•UPS literature kit containing:
–product documentation
–safety information
–warranty information
100 V models: | ||
• | PowerChute® CD | • Serial communication |
• | Serial communication | cable |
| cable |
|
4.Place the UPS where it will be used.
–Ensure that air vents on the front and rear of the UPS are not blocked.
–Do not operate the UPS where there is excessive dust or the temperature or humidity are outside the specified limits.
2.52.5
cm cm
40°C | 95% |
104°F | |
| 0% |
3 |