Surge Protected COAX/RF Connectors, Circuit Breaker

2Surge Protected COAX/RF Connectors

The H10 provides surge protection for your CATV system, Cable Modem, DSS, or Antenna system. The surge protection feature prevents surges traveling over Coaxial data lines from damaging the system.

Connect the coaxial cable from the CATV or Cable Modem provider to the connector marked “IN.”

Connect other cable from the connector marked “OUT” to the device being protected (CATV box or Cable Modem).

3System Ground Terminal

The H10 provides for the connection of grounding wires from all of your equipment to a central terminal lug. This ground connection eliminates ground loop problems; tie all component grounds to this screw to break any possible ground loops that can cause an audible ‘hum’.

Circuit Breaker

The H10 also provides a “press-to-reset” circuit breaker. When this breaker is “tripped” due to an electrical surge or overload, the device pops out and shuts down output power to the outlets. To reset the circuit breaker, push it straight inward.

CAUTION: When resetting the Circuit Breaker, push the but- ton in quickly, and release the button. Do not hold the button inward. Failure to comply may result in equipment damage.

Input Power Connector

Connect one end of the supplied AC power cord to the H10 Input Power Connector, connect the other end to the AC utility power source (15 Amp, 120 Vac, 50-60 Hz).

- 9 -