APC H10 manual Federal Communications Commission FCC Compliance Information

Page 22

CAUTION: When connecting to the DC Trigger jacks, connect the source of the DC trigger to the IN jack. The OUT jack should be used only as a pass-through. The DC Trigger signal can be short circuited if the input and output cables are reversed. The maximum input volt- age for the DC Trigger is 30VDC. Do not apply an AC voltage to the DC trigger jacks. Failure to comply with this statement may result in equipment damage.

Physical Dimensions (H x W x D)

3.75 x 17 x 9.5”

 

 

Weight: Unpackaged / Shipping

16.7 lbs. / 17.5 lbs.

 

 

Safety Agency Approvals

UL1449, cUL,

 

FCC Part 68 Class B

 

 

Federal Communications Commission (FCC) Compliance Information

This device complies with Part 68 and Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device must not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. As required, the bottom of this equipment contains, among other information, the Registration Number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be provided to the telephone company.

- 14 -

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model H10 Type Power Conditioner Page Safety Information Safety Information Safety Symbols Page Front and Rear Panels Page Introduction Proven Expertise…Proven ReliabilityUnit Power Capacity Safety PrecautionsPackage Contents FeaturesDC Trigger Surge ProtectionIsolated Noise Filter Banks Infb Removable Support FeetFiltering Status Indicator Front Panel Controls and IndicatorsLine OK Status Indicator Line Boost Status IndicatorLine Trim Status Indicator Switched On Status IndicatorDelayed On Status Indicator SEQ/AVR Push ButtonOverload Status Indicator To set the Delay time for the sequenced outlets10 On/Off switch LED Display and Unit CustomizationRear Panel Connectors and Circuit Breaker H10 Rear Panel ConnectorsAC-Powered Outlets System Ground Terminal Surge Protected COAX/RF ConnectorsInput Power Connector Circuit BreakerDC Trigger jacks Additional Surge Protected COAX/RF ConnectorsSurge Protected Telephone Jacks Apply Power InstallationMake Connections Set Up the H10 Technical Specifications SpecificationFederal Communications Commission FCC Compliance Information Troubleshooting Unit will not turn onWiring OK Indicator LED is not illuminated Technical Support
Top Page Image Contents