APC manual Rear Panel Connectors and Circuit Breaker, H10 Rear Panel Connectors

Page 15

Rear Panel Connectors and Circuit Breaker

The rear panel connectors for the H10 Power Conditioner are detailed in Figure 3. Each numbered callout refers to the numbered description found in the following pages.

Figure 2. H10 Rear Panel Connectors

Note: All outlets provide surge protection, voltage regulation, and noise filtering.

- 7 -

Image 15

Contents Model H10 Type Power Conditioner Page Safety Information Safety Information Safety Symbols Page Front and Rear Panels Page Proven Expertise…Proven Reliability IntroductionFeatures Safety PrecautionsPackage Contents Unit Power CapacityRemovable Support Feet Surge ProtectionIsolated Noise Filter Banks Infb DC TriggerLine Boost Status Indicator Front Panel Controls and IndicatorsLine OK Status Indicator Filtering Status IndicatorSEQ/AVR Push Button Switched On Status IndicatorDelayed On Status Indicator Line Trim Status IndicatorLED Display and Unit Customization To set the Delay time for the sequenced outlets10 On/Off switch Overload Status IndicatorH10 Rear Panel Connectors Rear Panel Connectors and Circuit BreakerAC-Powered Outlets Circuit Breaker Surge Protected COAX/RF ConnectorsInput Power Connector System Ground TerminalAdditional Surge Protected COAX/RF Connectors DC Trigger jacksSurge Protected Telephone Jacks Installation Apply PowerMake Connections Set Up the H10 Specification Technical SpecificationsFederal Communications Commission FCC Compliance Information Unit will not turn on TroubleshootingWiring OK Indicator LED is not illuminated Technical Support