APC H10 manual Safety Symbols

Page 5

Protect Your Investment

Congratulations and thank you for selecting and investing in APC's Model H10 Power Conditioner. At APC, we know you have made an intelligent choice sure to reward you for many years. To ensure you receive all the benefits and protection that accompany your purchase, please take a few minutes to fill out and mail the enclosed Warranty Registration Card, or complete the online form at www.apc.com.

Note: Under California law, failure to register your purchase may not exclude you

from provisions of the Warranty and Equipment Protection Policy.

Benefits of warranty registration are outlined below.

Registration

By registering your purchase now, it guarantees you will receive all the information and special offers you qualify for as the owner of this product.

Verification

By registering your purchase now, confirms your right to maximum protection under the terms and conditions of the Warranty, and Equipment Protec- tion Policy.

Confirmation

By registering your purchase now, you have a way to confirm yourself as the owner of the product in the event of fire, theft or loss.

Safety Symbols

This “bolt of lightning” indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your home, please do not remove the product cover.

This “exclamation point”

!calls attention to features for which you should read about in this Manual to prevent operating and maintenance problems.

Warnings, Cautions and Notes

Warnings

Warnings provide information about a procedure which, if not performed exactly as stated, may result in injury or death.

Cautions

Cautions provide information about a procedure which, if not performed exactly as stated, may result in equipment damage.

Notes

Notes provide information which we feel is essential to highlight.

iii

Image 5
Contents Model H10 Type Power Conditioner Page Safety Information Safety Information Safety Symbols Page Front and Rear Panels Page Proven Expertise…Proven Reliability IntroductionPackage Contents Safety PrecautionsUnit Power Capacity FeaturesIsolated Noise Filter Banks Infb Surge ProtectionDC Trigger Removable Support FeetLine OK Status Indicator Front Panel Controls and IndicatorsFiltering Status Indicator Line Boost Status IndicatorDelayed On Status Indicator Switched On Status IndicatorLine Trim Status Indicator SEQ/AVR Push Button10 On/Off switch To set the Delay time for the sequenced outletsOverload Status Indicator LED Display and Unit CustomizationH10 Rear Panel Connectors Rear Panel Connectors and Circuit BreakerAC-Powered Outlets Input Power Connector Surge Protected COAX/RF ConnectorsSystem Ground Terminal Circuit BreakerSurge Protected Telephone Jacks Additional Surge Protected COAX/RF ConnectorsDC Trigger jacks Make Connections InstallationApply Power Set Up the H10 Specification Technical SpecificationsFederal Communications Commission FCC Compliance Information Unit will not turn on TroubleshootingWiring OK Indicator LED is not illuminated Technical Support