Start Up
Accessories
This UPS is equipped with an accessory SmartSlot. Refer to the APC Web site, www.apc.com for available accessories.
If a standard accessory, such as a SNMP card is installed on this UPS, refer to the Utility CD for user documentation.
Install accessories prior to connecting power to the UPS.
Start Up
Connect Equipment and Power to the UPS
1.The UPS features a transient voltage 
located on the rear panel, for connecting the ground lead on surge suppression devices such as telephone and network line protectors.
Prior to connecting the grounding cable, ensure that the UPS is NOT connected to utility or battery power.
2. Connect equipment to the UPS.
NOTE: This UPS is equiped with an external battery connector on the rear panel of the unit.
Where appropriate use an APC extension battery cable. For ordering details contact your dealer or APC through the Web site www.apc.com.
3.Add optional accessories to the SmartSlot located on the rear panel.
4.Plug the UPS into a
–230 V models: The utility power cord is supplied in the UPS literature kit. Prior to connecting the utility power, connect the ground lead (optional) to the TVSS screw.
5.120 V models: Check the SITE WIRING FAULT LED 
located on the rear panel. The LED will be illuminated if the UPS is plugged into an improperly wired utility power outlet, (see Troubleshooting).
6.To use the UPS as a master on/off switch be sure all connected equipment is switched on.
Rear Panels
120 VAC
230 VAC
5 |