APC 1500RMXL2U, SURTA2200RMXL2U Installation, Specifications, Rack-Mount and Stack Configurations

Page 7

Specifications

Temperature

Operating

0° to 40° C (32° to 104° F)

 

 

Storage

-15° to 45° C (5° to 113° F)

 

 

charge UPS battery every six months

 

 

 

 

 

Maximum

Operating

3,000 m (10,000 ft)

Elevation

 

 

Storage

15,000 m (50,000 ft)

 

 

 

Humidity

0% to 95% relative humidity, non-condensing

This unit is intended for indoor use only. Select a location sturdy enough to handle the weight.

Do not operate UPS where there is excessive dust or temperature or humidity are outside specified limits.

This unit has side air vents. Allow adequate space for proper ventilation.

Environmental factors impact battery life. High temperatures, poor utility power, and frequent, short duration discharges will shorten battery life.

Installation

Units may vary in appearance from those depicted in this manual. Always place UPS above XLBPs in rack-mount configuration. The unit is heavy. Remove the battery prior to installation.

Prior to connecting utility or battery power to the UPS connect the transient voltage surge-suppression (TVSS) screw.

Rack-Mount and Stack Configurations

Refer to the installation guide supplied with the rail kit for rack-mount configuration instructions.

Tower Configuration

The UPS is shipped with stabilizer brackets installed. Do not remove the stabilizer brackets when the UPS is to be operated in tower configuration. Removal of the stabilizer brackets for tower configuration may result in personal injury or equipment damage.

External Battery Pack(s)

Refer to the user manual supplied with the external battery pack for installation instructions.

SURTA 1500XL/1500XLJ/2200XL Series 100/120 Vac Tower/Rack-Mount 2U

5

Image 7
Contents Installation and Operation Page Smart-UPS Inventory AccessoriesSafety OverviewDescription IndicatorProduct Overview Front display panelRear panel Front Display Panel Description FeatureTower Configuration InstallationSpecifications Rack-Mount and Stack ConfigurationsConnect equipment to the UPS Connect the Internal Battery Install the BezelConnect Power and Start the UPS OperationUPS Settings ConfigurationFunction Factory Default Options Description Connect the EPO Emergency Power Off EPOTerminal Mode to Configure UPS Parameters UPS will not turn off TroubleshootingUPS does not provide expected backup time Site Wiring Fault indicator is illuminatedBypass indicator is illuminated Battery Fault indicator is illuminatedFault indicator is illuminated Battery replacement Maintenance and TransportPrepare the UPS for transport Contact Information ServiceAPC Worldwide Customer Support Two-Year Warranty Limited WarrantyVac models Radio Frequency Warning990-3622 2009