Connect Equipment to the UPS

2:START UP

Rear Panel

∙Note: A laser printer draws significantly more power than other types of equipment and may overload the UPS.

Connect the UPS to the Network (if Applicable)

Network Connectors

Serial Port Modem/Telephone/Fax	Network Surge
Ports	Suppression Ports

Use only interface kits approved by APC.

Use only the supplied cable to connect to the serial port. A standard serial interface cable is incom- patible with the UPS.

The UPS features modem/telephone/fax surge suppression ports. Connect a single mo- dem/telephone/fax line into the RJ-11 modem/telephone/fax surge protection IN jack on the back of the UPS. Use telephone cabling (not supplied) to connect the OUT jack to a modem/telephone/fax port.

The UPS also features network surge suppression. Connect a single line 10 Base-T/ 100 Base-Tx network cable into the RJ-45 network surge protection IN jack on the back of the UPS. Use network cabling (CAT6 cable supplied) to connect the OUT jack to a network port.