Removing the front door (optional)
Note: Front door removal is NOT a requirement for this installation. However, removing the door will allow better access to the internal components.
1.Place the MBP on its back such that its front door is facing straight up.
2.Use the enclosed keys to unlock and then open the front door.
3.Disconnect the internal ground cable from the ground stud on the door. Use an M10 nut driver to remove the M6 flange nut securing the cable to the stud.
4.Using your thumb and forefinger, pull the three rubber plugs off the bottom ends of the three hinge clips.
5.Using pliers, remove the three hinge clips connecting the door to the enclosure.
6.Remove the door. Store the door and all hardware in a safe location for later
Front Door Locks (2)
Rubber Plugs (3)
Hinge Clips (3)
Hinges (3)
8 |