Re-attaching the front door

Note: This section applies only if the front door was removed at the start of the installation process. If you chose not to remove the door, ignore this section.

Re-attaching the front door requires at least two people: one to hold the door in place, and the other to make the necessary hardware connections.

1.Holding the door at an angle to the MBP enclosure, re-insert the three hinge clips into the three door hinges.

2.Using your thumb and forefinger, push the three rubber plugs onto the bottom ends of the three hinge clips.

3.Keeping the door open, re-connect the internal ground cable to the ground stud on the inside of the door. Place the M6 flange nut over the cable lug on the stud. Use an M10 nut driver and torque to 120in-lbs [14Nm].

4.Close and lock the front door.

Hinge Clips (3) 

Hinges (3)

Rubber Plugs (3) 

Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation