AMX NXA-UPS1500 manual Operation

Page 26

Operation

3.If the battery voltage is detected lower than set limit, the Battery Replacement mark will blink for 5 times then extinguish to stop self-test procedure. And if battery is detected weak or dead, the Battery Replacement mark will steadily illuminate.

The UPS will remain at “NO” output, if the start-up operation is not proceeded properly even though the Input Power Cord is connected to the wall receptacle.

IMPORTANT - Plug the UPS onto the wall receptacle to charge the UPS for over 8 hours after initial installation.

Store at -15 to +30 °C (+5 to +86 °F), charge the UPS battery every six months.

Store at +30 to +45 °C (+86 to +113 °F), charge the UPS battery every three months.

22

NXA-UPS1500 Uninterruptible Power Supply

Image 26
Contents NXA-UPS1500 AMX Limited Warranty and Disclaimer Table of Contents Battery Replacement Overview NXA-UPS1500 Uninterruptible Power SupplyFeatures Product Specifications NXA-UPS1500 Product SpecificationsFront Panel LCD Other AMX EquipmentNXA-UPS1500 Uninterruptible Power Supply Important Notice Storage InstructionsImportant Safety Instructions Assembling the Battery Pack Accessing the Battery Compartment Step One Accessing the Battery Compartment Step TwoAccessing the Battery Compartment Step Three Page Place the UPS Properly Accessories for Tower and Rack MountMounting the NXA-UPS1500 UnpackingSelecting Installation Position UPS SetupTower Setup Step Two Tower SetupTower Setup Step One Rack-Mount Setup Step Two Rack-Mount SetupRack-Mount Setup Step One Rack-Mount Setup Step Three Rack-Mount Setup Step FourRack-Mount Setup Step Five Connecting the UPS Connect Utility and LoadConnect Network Surge Protection Connect the RS-232 Communication PortRS-232 Communication Port Pin Assignment NetLinxUPSConnecting the UPS NXA-UPS1500 Uninterruptible Power Supply Operation Operation Replacing the UPS Battery Step One Battery ReplacementAssembling the Battery Pack Recycling the Used Battery Replacing the UPS Battery Step TwoReplacing the UPS Battery Step Three NXA-UPS1500 EPM Installation Important Safety InstructionsEPM Specifications Important NoticeUnpacking EPM Installation and OperationSelecting Installation Position Tower Installation Step Two EPM Installation InstructionsTower Installation Step One Use With UPS Step Two Using the EPM With The UPSUse With UPS Step One Rack Mount Installation Step Two EPM Rack Mount InstallationRack Mount Installation Step One Rack Mount Installation Step Three Rack Mount Installation Step FourConnecting the EPM To the UPS EPM Storage InstructionsReplacing the Battery in the EPM Step Two Replacing the Battery In the EPMReplacing the Battery in the EPM Step One Replacing the Battery in the EPM Step Three Replacing the Battery in the EPM Step FourUPS Maintenance NXA-UPS1500 Uninterruptible Power Supply It’s Your World Take Control