Ultra Electronics Card Systems | Quick Start Guide |
Clip the card Feed Hopper to the end of the Sicura card laminator. Make sure the Card Deflection Plate is fitted.
Position the Sicura against the Printer so that cards frpm the printer drop into the hopper.
Connect the interface cable from the laminator. Check that the DIL Switch selections are ‘UP’ (see Section F4).
Switch on and allow the laminator to warm up. Print and laminate a test card by operating the Test pushbutton at the rear of the printer.
Note:
The Rio/Tango printer can print cards faster than the Sicura can laminate them. There is a hopper capacity of about 12 cards, but to reduce the speed discrepancy, it is recommended that the printer is operated in ColorSure mode (refer to the Rio/Tango
An interface cable ensures that the printer does not feed cards into the Sicura laminator until the laminator is ready.
MAGICARD Sicura Laminator | Page 15 |