Ultra electronic Sicura Laminator quick start Important Cleaning Procedures, Preparation

Quick Start Guide Ultra Electronics Card Systems

L Important Cleaning Procedures

Correction operation depends on clean rollers to transport cards, an undamaged laminating roller, and a dust-free environment.

It is recommended that the laminator be cleaned after every roll of lamination film (250 cards).

PREPARATION

Set the temperature controller to 20°C, then switch off.

Allow to cool down for 15 minutes.

Remove cards and both film cores.

CLEAN DUST FROM FILM BOSSES

Using a slightly damp cloth, wipe any plastic dust from the two film core bosses, the retaining plate, and any visible dusty surfaces.

CLEAN THE ROLLERS

Switch the laminator on.

Using a slightly damp cloth, wipe the exposed surfaces of the two pinch rollers and the laminating roller. Operate the open/close lever to turn the rollers.

Switch off and allow to dry.

RE-LOAD

Re-load the laminator with a fresh roll of film and take-up core. It is not recommended that take-up cores be re-used.

New cores are supplied with each roll of film.

Switch on and set the temperature controller to the desired laminating temperature.

When warmed up, laminate two or three plain cards to get rid of any residual dust and to check the film alignment on the card.

Page 20 MAGICARD Sicura Laminator