Ultra electronic Sicura Laminator quick start Adjusting the Hopper

Page 18

Quick Start Guide

Ultra Electronics Card Systems

J Adjusting the Hopper

The Card Feed Hopper has been factory set for use with 30 thou cards. Should it require adjustment, carry out the following procedure:

Remove the hopper from the laminator, remove the interface cable.

Insert a stack of your normal cards to be laminated. Cards should be flat for correct feeding.

View the cards edge-on at the card exit aperture and adjust the shutter screw so that 1½ cards thicknesses are exposed.

Re-fit the Card Feed Hopper and the cable.

Check for correction operation.

Page 18

MAGICARD Sicura Laminator

Image 18

Contents Magicard Sicura Laminator Stand-alone Mode Preparing a Location for Sicura Laminator and Printer Location Requirements for your laminator/printerRemoving the Laminator from the Box Checking the C Package Contents Quick Start Guide Ultra Electronics Card Systems Install the D Lamination Film Quick Start Guide Ultra Electronics Card Systems Connect the Laminator E To a Power Supply Quick Start Guide Ultra Electronics Card Systems Ultra Electronics Card Systems Quick Start Guide Rotary Switch and DIP Switch Adjustments Ultra Electronics Card Systems Quick Start Guide Interfacing to a RIO/TANGO Printer Ultra Electronics Card Systems Quick Start Guide InterfacingPrinter to a Turbo Series Operating the Hopper/Sicura in Stand Alone Mode Adjusting the Hopper Error Indicators K Important Cleaning Procedures PreparationCase of Difficulty M Canadian Department of Communications Statement Ultra Electronics Limited EC Declaration of Conformity