SEAL AS-1600 operation manual Web the Laminator, Web Diagram Method

Page 14

Section 2. Operating Procedures

3. Web the Laminator

A Web diagram is provided in Figure 2.3 Below

Figure 2.3 Web Diagram

Method

1.Lift Unwind Assembly to the UP position.

2.Load a take-up core onto the Take-up Mandrel and align with the edge of the roll of media on the Unwind Mandrel.

3.Pull media up over the web Idler, under the Draw down Assembly and under the Dryer Assembly to the Take-up Core.

4.Tape material to the Take-up core.

Note: It is important to get the material as straight as possible to ensure a minimal amount of “telescoping” on the Take-up Roller.

13

Image 14

Contents Owner’s Operation Manual Preface This manual contains the following SectionsTable of Contents Warranty Safety Information Intended UseSafety Labels Introduction Hardware OverviewIntroduction Introduction Control Panel Rear View Loading Materials Operating ProceduresTools/Supplies Required Pre-heat the Laminator Heater Control locationsWeb Diagram Method Web the LaminatorRun the Laminator Applicator NozzleUnwind Mandrel Brake Adjust Cleaning the Laminator Clean Up ViewTroubleshooting Problem / Symptom Causes Corrective ActionTroubleshooting After Sales Support Asia Pacific