SEAL AS-1600 operation manual Unwind Mandrel Brake Adjust

Page 16

Section 2. Operating Procedures

6.Adjust Brake tension so that the material is pulling through smoothly with no wrinkles.

Figure 2.5 Unwind Mandrel Brake Adjust

7.When the media being coated comes to an end, the last piece will loose tension; you will need to manually provide back-tension as the media runs out.

8.Approximately 1.6M (5 ft) prior to the last piece of media going past the Draw Down Assembly the Flow control valve at the Applicator Nozzle should be closed.

9.Once the material is through the Dryer Panel, the Dryer switch should be turned OFF.

10.The finished material is easily unloaded by swinging the Take-up Mandrel out and slipping the finished roll off the mandrel.

Image 16

Contents Owner’s Operation Manual Preface This manual contains the following SectionsTable of Contents Warranty Safety Information Intended UseSafety Labels Introduction Hardware OverviewIntroduction Introduction Control Panel Rear View Tools/Supplies Required Operating ProceduresLoading Materials Pre-heat the Laminator Heater Control locationsWeb Diagram Method Web the LaminatorRun the Laminator Applicator NozzleUnwind Mandrel Brake Adjust Cleaning the Laminator Clean Up ViewTroubleshooting Problem / Symptom Causes Corrective ActionTroubleshooting After Sales Support Asia Pacific