Pre-heat the Laminator, Heater Control locations

Section 2. Operating Procedures

2. Pre-heat the Laminator

All Pre-heat control operations are controlled from the Control Panel as shown in Figure 2.2

1.Switch machine to START at the Main Power Switch

∙Laminator will power-up

∙Dryer Panel is in the UP position.

∙Heaters are OFF.

Set Button

Up Button

Down Button

Figure 2.2 Heater Control locations

2.On the Heater Controller, press and hold the SET button to check the set-point temperature. Adjust the set point by holding the SET button down and using the UP/DOWN arrows to scroll to the desired temperature setting.

Note: Most vinyl’s run well with a SET POINT temperature of 315°C (600°F) dependent on speed.

3.Press the Heater Switch to ON to power the Dryer Panel and begin heating.

4.Once the machine reaches its SET POINT it is ready to be operated.