ES-1300C
8.If the room temperature is low(under 64f), The ready light may take longer to come on.
9.Retractable Cooling Guide is for the pouch film only. (Excessive pressure will cause guides to break.)
10.Plug the laminator in after verifying the correct voltage. Failure to comply with the above information could result in serious injury.
HOT LAMINATING PROCEDURE
1.Do not operate the laminator until the ready light is on. The Ready light will appear after 10 minutes of warm up time.
(The above directions are for 3 mil. When switching 3 mil to 4 & 5 mil pouches please wait an additional 2~3 minutes.)
Picture 1
Picture 2
Picture 3
Power Switch
l:Power on o : Power off
Mode Switch
This position is for low temperature mode. Please wait 10 minutes for the machine to warm up.
Mode Switch
This position is for high temperature mode.
Please wait 12 minutes for the machine to warm up. If you are switching from 3 mil mode you will only need to wait
5