Display Control Panel | GBC 1244WF, 1264WF specification

GBC 1264WF/1244WF

Operation Manual

Section 7: Display Control Panel

Stand-by

Pressing STAND-BYwill cause the laminator to go into the AUTO-OFF mode. The laminator will automatically go into this mode after sitting idle for an extended amount of time. When in AUTO-OFF mode the laminator will no longer continue to heat the main rollers to save power.

Stand-by

Pressing MEMORY will cause the current speed and heat settings to be recorded in the JOB memory location shown on the display.

Jobs

Pressing the up or down arrows will cause the unit to cycle through stored jobs. Up to 9 separate jobs can be stored. To save a job, select one of the nine jobs to overwrite. Then change the heat and speed settings as required for your application. Once selected, press the memory button once.

Measure

Press and hold the MEASURE key to display the current roller temperature.

Cooling

When the COOLING button is pressed the cooling fans will turn on or off. The COOLING button will illuminate green when the fans are on. The fans blow fresh air on the film web in between the heat and pull rollers.

Run

When the RUN is pressed the rollers will begin turning. However, pressing run will not cause the rollers to turn when any of the following are true: the Emergency Stop is engaged, Safety Shield is raised or removed and/or the feed table is removed.

Page 17