Tips for Pre Coating Boards

Operation Manual

MOUNT

ADHESIVE

1. Load the laminator as illustrated in (Fig. 15). Remove

chill idler.

TRAILOR BOARD

LEADER BOARD

2.	The width of the roll should not exceed the width of
	the board by more than 1/2 in. (1.3 cm).
3.	Use a leader board to set the main roller and pull roller

BOARDS

Fig. 15

IMAGE

RELEASE LINER

PRE-COATED BOARD

Fig.16

MOUNT

ADHESIVE

RELEASE LINER FROM PSA FILM

OUTPUT

IMAGE

KRAFT

PAPER

OPTION

Fig. 17

	pressure prior to webbing.
4.	Use a leader board to start the run and a trailer board to
	finish the run.
5.	Using the pull rollers will allow you to leave gaps
	between boards.
6.	If not using the pull rollers, have the boards nearby to
	butt end to end during feeding.

Tips for Mounting Pre Coated Boards

1.Use a leader board to set the main roller pressure prior to mounting the image.

2.Ensure the chill idler is removed and the rear slitter is to one side.

3.Do not stop once you have started the mounting process through the machine. (Fig. 16)

Note: This application can also be performed from the rear operating position.

1.Load the laminator as illustrated in Fig. 17.

2.Use Kraft paper for one-sided lamination When ever the items to be laminated are narrower than the film you are using.

3.If not using Kraft paper, use a scrap piece to finish the run or you will have adhesive on your rollers.

4.For high volume runs, use Kraft paper and the lower rear rewind for roll to roll operation.

5.Running the web over the chill idler may improve the Flatness of the output.

6.A little heat, 125 degree F (52 degree C), may help eliminate silvering effects associated with PSA films.

Page 32