GBC 1244WF, 1264WF operation manual Auto-Off, Ready

GBC 1264WF/1244WF Operation Manual

Display Control Panel-Continued

The Temperature displayed in the area referred to as TOP TEMPERATURE and BOTTOM TEMPERATURE is the value that the laminator is attempting to attain. Pressing the MEASURE button will momentarily display the actual roller temperature.

The current speed and job settings are given on the right side of the display.

The current state of the heat rollers is given on the lower portion of the display. The unit will always be in one of three states: AUTO-OFF, READY, or WAIT.

Auto-Off

In the AUTO-OFFstate (also referred to as Standby) the unit will no longer continue to heat the main rollers. The unit will go into this state after a period of inactivity or by pressing the STAND-BYkey. Press the STAND-BYkey to bring the unit out of AUTO-OFFmode. See Fig. A

Ready

The READY icon will flash when the actual roller temperature is nearing but not quite met the target temperature.

The READY icon will be displayed continually when the actual roller temperature is within +/- 15* F of the target temperature entered by the operator. See

Fig. B

Wait

The WAIT icon is displayed when the actual roller temperature is much higher or lower than the target temperature entered by the user. See Fig. C

Fig. A

Fig. B

Fig. C

© 200 6 General Binding Corporation Page 19