GBC 1264WF/1244WF
IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT TO GBC. IN THIS INSTRUCTION MANUAL AND ON THE PRODUCT, YOU WILL FIND IMPORTANT SAFETY MESSAGES REGARDING THE PRODUCT. READ THESE MESSAGES CAREFULLY. READ ALL OF THE
INSTRUCTIONS AND SAVE THESE INSTRUCTIONS FOR LATER USE.
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY MESSAGE IN THIS INSTRUCTION MANUAL. THE SYMBOL INDICATES A POTENTIAL PERSONAL SAFETY HAZARD TO YOU OR OTHERS. THE FOLLOWING WARNINGS ARE FOUND UPON THIS PRODUCT.
ADVERTENCIA | Attention |
| Avertissement |
Riesgo de choque | Risque de |
| Electrical shock |
eléctrico | Secousseélectrique. |
| hazard. |
No abra: | Ne pas ouvrir. |
| Do not open. |
Adentro no hay | Pas de pièces |
| No user serviceable |
piezas reparables | réparables par |
| parts inside. |
por el usuario. | l'utilisateur. |
| Refer servicing to |
Mantenimiento | Entretien |
| qualified service |
solamente por | seulement par |
| personnel. |
personal calificado | personnel qualifié. |
|
|
THIS SAFETY MESSAGE MEANS THAT YOU COULD BE SERIOUSLY HURT OR KILLED IF YOU OPEN THE PRODUCT AND EXPOSE YOURSELF TO HAZARDOUS VOLTAGE.
ADVERTENCIA | Attention |
| Avertissement |
RODILLOS | ROULEAUX |
| HOT ROLLS. |
CALIENTES. | CHAUDS. |
|
|
PUNTO DE | POINT DE |
| PINCH POINT. |
PINCHAMIENTO. | PINCEMENT. |
|
|
Mantener manos y | Tenir mains et |
| Keep hands and |
ropa a distancia. | vêtements à |
| clothing away. |
| l'écart. |
|
|
THIS SAFETY MESSAGE MEANS THAT YOU COULD BE BURNED AND YOUR FINGERS COULD BE TRAPPED AND CRUSHED IN THE HOT ROLLERS. CLOTHING, JEWELRY AND LONG HAIR COULD BE CAUGHT IN THE ROLLERS AND PULL YOU INTO THEM.
ADVERTENCIA | Attention |
| Avertissement |
NAVAJA FILOSA. | LAME |
| SHARP BLADE. |
| COUPANTE. |
|
|
Mantener manos y |
|
| Keep hands and |
dedos a distancia. | Tenir mains et |
| clothing away. |
| doigts à l'écart. |
|
|
|
|
|
|
THIS SAFETY MESSAGE MEANS THAT YOU COULD CUT YOURSELF IF YOU ARE NOT CAREFUL.
WARNING: THIS SAFETY ALERT SYMBOL PRECEDES EACH SAFETY
MESSAGE IN THIS INSTRUCTION MANUAL. THE SYMBOL INDICATES A POTENTAL PERSONAL SAFETY HAZARD TO YOU OR OTHERS.
WARNING: DO NOT ATTEMPT TO SERVICE OR REPAIR THE 1264/1244 WF LAMINATOR.
WARNING: DO NOT CONNECT THE
LAMINATOR TO AN ELECTRICAL SUPPLY OR ATTEMPT TO OPERATE THE
LAMINATOR UNTIL YOU HAVE
COMPLETELY READ THESE
INSTRUCTIONS. MAINTAIN THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR FUTURE REFERENCE.
Operation Manual
IMPORTANT SAFEGUARDS
WARNING: TO GUARD AGAINST INJURY
THE FOLLOWING SAFETY PRECAUTIONS MUST BE OBSERVED IN INSTALLATION AND USE OF THE LAMINATOR.
General:
Keep hands, long hair, loose clothing, and articles such as necklaces or ties away from the front of the heat and pull rollers to avoid entanglement and entrapment.
The heat rollers can reach temperatures over 300˚F (150°C). Avoid contact with the heat rollers during operation or shortly after power has been removed from the laminator.
Keep hands and fingers away from the path of the sharp film cutter blades.
Do not use the laminator for other than its intended purpose.
Avoid moving the Laminator on uneven floor surfaces. Never tilt the laminator.
Do not defeat or remove electrical and mechanical safety equipment such as interlocks, shields and guards.
Do not insert objects unsuitable for laminating or expose the equipment to liquids.
Electrical:
The Laminator should be connected only to a source of power as indicated in these instructions and on the serial plate located on the rear of the laminator. Contact an electrician should the attachment plug provided with the Laminator not match the receptacles at your location.
WARNING: THE RECEPTACLE MUST BE LOCATED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.
Do not operate the Laminator with a damaged power supply
cord or attachment plug, upon occurrence of a malfunction, or after the laminator has been damaged. Contact GBC’s
Technical Service Department or your dealer/distributor for assistance.
Service:
Perform only the routine maintenance procedures referred to in these instructions
WARNING: DO NOT ATTEMPT TO SERVICE OR REPAIR THE LAMINATOR
Disconnect the plug from the receptacle and contact GBC’s Technical Department or your dealer/distributor when one or more of the following has occurred.
∙The power supply cord or attachment plug is damaged.
∙Liquid has been spilled into the laminator.
∙The laminator is malfunctioning after being mishandled.
∙The laminator does not operate as described in these instructions.
© 200 6 General Binding Corporation | Page 4 |